31100

Sterilizers

The hot bead sterilizer provides instant and effective sterilization of surgical instruments directly at the workplace. The working temperature of the glass beads is 250º C and it sterilizes in 10-15 seconds, and after 30 seconds the sterilized parts are cool enough for use. The sterilizers exterior stays cool even after being used a full day's work and is safe to use even in laminar flow hoods. It is available with two different depths; 8 cm (most common) and 14 cm.

Please remember to properly clean the instruments with a pH neutral detergent and distilled water before placing them into the sterilizer.

Art. No.
Description
Price

31100

Steri 250, hot bead sterilizer 8cm depth

Request Quote

31170

Steri 350, hot bead sterilizer 13cm depth

Request Quote

31120

Spare glass beads for Steri 250/350, 150g

Request Quote

Instructions

  1. Fill the container with dry and clean STERI glass beads 2 mm below rim. Never fill the container with other material or liquids.
  2. Switch on the sterilizer. After the heating-up time the inner temperature reaches approx. 240–270°C which is maintained as long as the sterilizer is switched on. ATTENTION! DO NOT TOUCH THE GLASS BEADS OR GLASS BEAD CONTAINER BEFORE COOLING DOWN!
  3. Remove the metal cover and do NOT place it back on the glass bead container until the sterilizer is switched off, to allow good ventilation of the outer case.
  4. Insert dry and clean instruments into the STERI glass beads as deep as possible for at least 10 seconds.
  5. The sterilizer can remain in constant use all day, with no overheating. The outer casing heats to approximately body temperature, which is normal. Current consumption is very low.
  6. When the day is over switch off the sterilizer. Place the metal cover on the glass bead container to keep out dust and foreign bodies.
  7. The STERI glass beads should be replaced monthly or refilled in a dry state after careful cleaning.
Read More Accept

We use cookies on this site to enhance your user experience

By clicking any link on this page you are giving your consent for us to set cookies.